<form id="npd99"><nobr id="npd99"><meter id="npd99"></meter></nobr></form>

<form id="npd99"></form>

      <form id="npd99"><nobr id="npd99"></nobr></form>

            Contact About US Home


            Chinese website

            Wenzhou Sugong Fluid Equipment Technology Co., Ltd.

            new productCurrent position:Homenew product

            SGM-SQ Hand-Air Aseptic Sampling Valve (PTFE)

            Date:[2019-01-15]     Click:


              Sterile sampling valves are primarily used for material sample collection in tank equipment or piping and require sterilization prior to and after each sampling. No dead ends, complete sterilization, continuous sampling and sterile sampling at any time. Widely used in food, wine, beverage, dairy products, toothpaste cosmetics, bio-pharmaceutical and other industries.

            Technical Parameters

            ◆Specifications: DN8 DN10 DN15

            ◆Connection method: welding, clamp, thread

            ◆Maximum working pressure: ≤8bar

            ◆Maximum sterilization pressure: ≤3bar

            ◆Working temperature: -10 ° C to 120 ° C

            ◆Maximum sterilization temperature: 120~150°C

            ◆Contact with material: SS316L Other parts SS304

            ◆Internal surface contact product: Ra≤0.8μm

            ◆ Seal: PTFE

            working principle

            This aseptic sampling valve is mainly divided into pneumatic components, handles, valve bodies, and diaphragm seals. When in the closed state, the valve core is pushed by the spring tension, and the sealing rubber head is pressed by the valve core to the inlet of the valve body material to achieve the sealing effect; if sampling is required, one of the sampling ports (usually the lower one) is passed through. Steam or other sterilizing medium, fill the entire sample chamber and export it from another sampling port. After a certain period of time, make the sample chamber and sampling port sterile; then shrink the spring by feeding air or lifting the handle. The valve core is loosened so that the sealing rubber head is detached from the inlet of the valve body material, so that the sample flows out of the tank through the sample chamber and is collected from the sampling port; after sampling, the gas source is closed or the handle is lowered, the spring is released, and the valve core is passed through the valve core. Press the sealant head again at the inlet of the valve body; pass the clean water to drain the residual liquid in the sample chamber (if the sample is a clean medium such as sterile water, this step can be omitted), then inject the sterilization medium. The seal is retained and will be sampled next time.

            Working principle diagram

                        Sampling state diagram           Sterilization state diagram

            new product
            intelligent controller
            Aseptic Sampling Valve
            Cut-off reversing valve
            Single-seat two-seat anti-mixing valve
            Pressure Safety Automatic Control Valve
            Regulating valve
            bottom valve
            Sterile diaphragm valve
            pneumatic butterfly valve
            Alcohol Equipment Valve
            Sanitary pump
            Sight glass
            High Clean Joint
            Wenzhou Sugong Fluid Equipment Technology Co., Ltd. Home


            About US


            News List


            Product List COPYRIGHT ? 2018 Wenzhou Sugong Fluid Equipment Technology Co., Ltd.