<form id="npd99"><nobr id="npd99"><meter id="npd99"></meter></nobr></form>

<form id="npd99"></form>

      <form id="npd99"><nobr id="npd99"></nobr></form>

            Contact About US Home

            Tel:0577-85210258

            Chinese website

            Wenzhou Sugong Fluid Equipment Technology Co., Ltd.

            new productCurrent position:Homenew product

            SGM-K manual quick-opening aseptic sampling valve (PTFE)

            Date:[2019-01-15]     Click:

            application

              Sterile sampling valves are primarily used for material sample collection in tank equipment or piping and require sterilization prior to and after each sampling. No dead ends, complete sterilization, continuous sampling and sterile sampling at any time. Widely used in food, wine, beverage, dairy products, toothpaste cosmetics, bio-pharmaceutical and other industries.


            Technical Parameters


            ◆Specifications: DN8 DN10 DN15

            ◆Connection method: welding, clamp, thread

            ◆Maximum working pressure: ≤8bar

            ◆Maximum sterilization pressure: ≤3bar

            ◆Working temperature: -10 ° C to 120 ° C

            ◆Maximum sterilization temperature: 120~150°C

            ◆Contact with material: SS316L Other parts SS304

            ◆Internal surface contact product: Ra≤0.8μm

            ◆ Seal: PTFE/SI/EPDM


            working principle


            This aseptic sampling valve is mainly divided into handle, valve body, bracket, valve core, spring, diaphragm seal ring. When in the closed state, the valve core is pushed by the spring tension, and the sealing rubber head is pressed by the valve core to the inlet of the valve body material to achieve the sealing effect; if sampling is required, one of the sampling ports (usually the lower one) is passed through. Into the steam or other sterilizing medium, fill the entire sample chamber and export it from another sampling port. After a certain period of time, the sample chamber and the sampling port are sterilized; then, by lifting the handle, shrinking the spring, and pulling the valve core The sealing rubber head is detached from the inlet of the valve body material, so that the sample flows out of the tank through the sample chamber and is collected from the sampling port; after the sampling is completed, the handle is released, the spring is released, and the sealing rubber head is pressed again through the valve core. At the inlet of the valve body material; pass the clean water to discharge the residual liquid in the sample chamber (if the sample is a clean medium such as sterile water, this step can be omitted), then inject the sterilization medium to seal and retain, wait for the next time sampling.


            Working principle diagram

                       Sampling state diagram           Sterilization state diagram

            new product
            intelligent controller
            Aseptic Sampling Valve
            Cut-off reversing valve
            Single-seat two-seat anti-mixing valve
            Pressure Safety Automatic Control Valve
            Regulating valve
            bottom valve
            Sterile diaphragm valve
            pneumatic butterfly valve
            Alcohol Equipment Valve
            Sanitary pump
            Sight glass
            Filter
            High Clean Joint
            Wenzhou Sugong Fluid Equipment Technology Co., Ltd. Home

            |

            About US

            |

            News List

            |

            Product List COPYRIGHT ? 2018 Wenzhou Sugong Fluid Equipment Technology Co., Ltd.
            色www影院免费观看入口_特级牲交大片30分钟_国产人成午夜免电影费观看_邻居熟妇不戴套在线观看